Home
 



Application

Floor Detection in Elevator and Lifts

Latching reed sensors can be mounted on each Floor, and the Magnet on the elevator or lift will actuate them as floors change. Latching reed sensors can be mounted in two ways with respect to the pole of the magnet. Reed Sensors on floor above can be latched and floors below can be unlatched, or vice-versa. The latched and unlatched condition of the sensors can be compared to electronic flip flops with built-in driver circuits, and have the added advantage of switching higher loads.
 

DESCRIPTION RS-04
Switching Type Form E (Latch)
Switching Voltage 200 VAC /  VDC max
Switching Current 3.0 A max
Switching Power 100w/ VA max
Breakdown Voltage 800 VDC Min
Contact Resistance with Cable 1 max
Operate Distance 20 - 35 mm

 

           

Also See the following Sensors

     
Infrared Vane Sensor for Elevator Floor Sensing Hall Effect based Vane Sensor Reed Sensor as door switch Water or Fluid level Sensor Magnetic Reed Sensor RF01 in plastic Barrel Housing Miniature Hall Effect Sensor Magnetic Reed Sensor - Flange type

Search our site for specific items, in either sensors, Switches, Connectors, or any Electronic & Elevator components


 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


Innovision offer its customers quality products and render support in application design. We supply the products of highest standards to meet customer expectation. Innovision enjoys the confidence of its customer by supplying leading products with a continued focus on "On Time Delivery". Innovision is committed to total customer satisfaction in all its products by continuously improving, updating the product range.

Copyright 2006
Innovision
All Right Reserved.